The measurement of film thickness during a vacuum deposition process can be accomplished with great accuracy and precision using a quartz crystal microbalance, or QCM. Under controlled conditions, it is possible to achieve Angstrom level resolution of the film thickness. In practice, however, this is rarely achieved. A film thickness monitor measures the change in resonance frequency of an oscillating quartz crystal while a thin film coating is collecting on its surface. As the coating builds up the resonance frequency decreases in a very predictable fashion. If the density of the deposited film is known, the thickness of the film can be calculated in real-time. A film thickness monitor works on the underlying assumption that any change in the resonance frequency is solely a result of film build-up.

Unfortunately, it does not always work out this way since quartz crystals can also change resonance frequency when exposed to a thermal gradient or mechanical stress. In a typical thin film deposition, both of these phenomena exist due to either normal_atthe deposition source radiation, highly energetic species (as in sputtering) or stresses caused by film condensation. Often these factors exist in concert. For ultra-thin film thickness measurements, in the 10 to 100 Angstrom

range, a combination of frequency shifts caused by heat, stress and film build-up can lead to thickness errors of 100% or more. As a result, the vacuum process becomes uncontrollable.

quartz crystal has been developed that mitigates these factors. Called the RC crystal, this recently invented design is insensitive to frequency shifts caused by source radiation or film stress. This is accomplished by adjusting the stress coefficients of the quartz plate using advanced fabrication methods.

The RC crystal will not show a rate spike when the deposition source shutter is opened. Typically, this action causes a frequency shift of up to 100 Hz, which translates for films such as aluminum, to rate changes of 50 Angstroms. Further, the noise associated with the intense energy of impingingRC atoms in sputtering is dramatically reduced, owing to the stress insensitivity of the crystal. These are very real advantages in the measurement of nanometer films used in the manufacture

of OLED’s, precision optical interference films, or next generation electronic devices. RC crystals can be used in place of standard AT-cut quartz in all commercially available film thickness monitors and controllers. RC crystals also can operate up to 300°C, which make them perfect for high temperature applications like CVD and ALD. They are made in 5 and 6 MHz versions, with gold, silver, nickel, aluminum, or custom electrodes, and they are in 14 mm (0.550″) diameter.

Stay tuned for more innovative updates, and be sure to check out our store where you can find our RC crystals in stock!